KNOWLEDGEBASE
- ★ Basic Troubleshooting Steps for EMT16, EMT16Plus and Bravo2
- ★ EMT16 or Bravo Not Detected By Melco OS or Bravo OS Software
- ★ Installing, Adjusting and Maintaining the Red Wide Angle Cap Frame Driver
- Hook Adjustment Procedures for EMT16Plus and EMT16*
- Installing the Red Wide Angle Cap Driver Mounting Assembly
- Madeira Starter Kit (Melco PN# 33341)
- Buying a Used Melco Embroidery Machine from a 3rd Party
- Network "Pairing" Feature
- Melco Embroidery Machine Transport Instructions
- Holders for Small Thread Cones
- Replacing Push-Pull Cable on AMAYA XT
- Machine Disconnecting from Melco OS or Bravo OS While Sewing
- Clearing a Bird's Nest From EMT16 or Bravo
- EMT16 or Bravo Briefly Goes Offline when Maintenance Notification Appears
- Connecting Melco Machines to Computers with No Ethernet Port
- Presser Foot In-Between Needles
- Keypad Functions
- Installing and Using the Slim Line Clamping System for the AMAYA, BRAVO, and EMT16
- Determining Machine Type - Beep Test
- Aligning and Replacing the Laser Assembly
- Extended Warranty Plans for Melco Embroidery Machines
- Replacing the Rotary Hook on the EMT16 and EMT16Plus
- Identifying and Using the Recommended Bobbin Case for EMT16
- Home Thread Feed Drive Gear
- Broken Hoop Arm Screw - PN#12392-01
- Machine Shuts Off at Random with no error messages
- Beeps When AMAYA Machine is Turned On
- XTS - Not Trimming Properly - Already Checked Trimmer
- Thread Looping Above the Pinch Rollers
- Thread From Needle 1 Catching On Thread Sensor