|
Status Light Condition |
Definition |
Action to Take |
|
Light is Green (continuous) |
Machine is on |
Load Design |
|
Light is Red (blinking slowly) |
Thread break |
Re-thread the affected needle |
|
Light is Red (blinking fast) |
Machine out of bobbin thread or there is a bobbin break |
Replace the bobbin or fix the bobbin break |
|
Light is Green for 2 sec., off for ½ sec. |
Machine is in low power shut-down (Sleep Mode) |
Wake Mode-Press Start for 3 sec.
Sleep mode-Press Stop for 3 sec. |
|
Green light blinking in 1 second intervals - with machines using Main Board 31058-19 (or older) |
The machine needs RSA/CSA files |
Release the red E-Stop, Check Force Download and Power Cycle. |
|
Light is Red (continuous) |
E-Stop is engaged |
Release the red E-Stop |
|
Light is Red (continuous) |
Turn off Sequin Device- Press Stop + Laser + Frame Back Buttons |
|
|
Alternating/Blinking between Red and Green |
n/a |
You will need additional technical assistance. Here are the available Melco Technical Support options. |
| Green Light stays on ~4 seconds and turns off for ~15 seconds.
|
n/a |
You will need additional technical assistance. Here are the available Melco Technical Support options. |