Follow

Home Thread Feed Drive Gear

1. Color change to needle 1.
2. Open Maintenance. Click on the Steppers tab.
3. Under the Color Change section click on Home. This will go to needle 1.
4. Under the section for Thread Feed click on Home. You will just hear a clicking noise.
5. Under Color Change click on Needle + to advance to the next needle.
6. Perform steps 3 & 4 for each needle.
7. Once all needles are done under Color Change click on Home. It will return he needle case to needle 1. You should not hear the clicking noise.
8. Close Maintenance.

Was this article helpful?
0 out of 0 found this helpful