Follow

Clicking Noise when moving to next color

Home Thread Feed Drive Gear Adjustment
1. Color change to needle 1.
2. Open Maintenance. Click on the Steppers tab.
3. Under the section for Thread Feed click on Home. You will just hear a clicking noise.
4. Under Color Change click on Needle + to advance to the next needle.
5. Perform steps 3 & 4 for each needle.
6. Once all needles are done under Color Change click on Home. It will return he needle case to
needle 1. You should not hear the clicking noise.
7. Close Maintenance.

If the Thread Feed Drive Gear requires replacement, please refer to this information below:

Was this article helpful?
0 out of 0 found this helpful