Original Amaya (BigRed) - Overview

Below are some listed differences between Original Amaya machines and other models.


For sewing on caps with the original AMAYA (prior to the cylindrical lower arm), Melco recommends using the raised needle plate (Melco P/N: 32196) that was included in the original Wide Angle Cap Frame Driver Kit (Melco P/N: 32198 - no longer available from Melco).  To install the needle plate, simply remove the regular needle plate by removing the screws holding it in place.  To do this use the special tool that is found in the AMAYA Operator’s Kit.  Then attach the raised needle plate by securely tightening the screws in place.  

When using this raised needle plate, you may encounter an increase in noise level.

Was this article helpful?
0 out of 0 found this helpful