Follow

XTS - Not Trimming Properly - Already Checked Trimmer

 

  • Check to see if the push pull cables are in the correct position - remove the needle plate and the silver plate behind it.
  • Remove the push pull cables from the back of the knife and selector. Remove the knife. The document attached to this article will show you how to remove it.
  • Install the ACA Trimmer Home Fixture, P/N 33539, lightly tighten the M3 screw and position the Push-Pull Cables in their respective holes as shown below. If the cables do go into the holes it is correct. If not it will need to be adjusted.

 

Was this article helpful?
0 out of 0 found this helpful